No. SS2-8113-0210 Azbil Corporation - 8 - DIMENSIONS Note) * : Face-to-face dimensions conform to following standards. -IEC 60534-3-1:2001 -JIS B 2005-3-1:2005 Note) “H” dimensions are applicable when a hand wheel is not provided. When a top-mounted hand wheel actuator is used, add the dimensions of hand wheel specified on Specification Sheet (No.SS2-8213-0500). Figure 4 Face-to-face and external dimensions Table 12 Face-to-face dimensions (Unit: mm) Nominal size (inches) A JIS 10K FF,RF ANSI 125FF JPI 125FF ANSI 150RF JPI 150RF * JIS 16KRF JIS20KRF JIS30KRF ANSI300RF JPI300RF * JIS40KRF ANSI600RF JPI600RF SW,BW * ANSI150RJ JPI150RJ ANSI300RJ JPI300RJ ANSI 600RJ JPI600RJ JIS20K Tongue and groove Male and female JIS30K Tongue and groove Male and female ANSI 1300LG JP1300LG Screwon Type 1/2 184 190 194 206 - 206 206 198 208 203 125 3/4 184 190 194 206 - 206 206 198 208 203 125 1 184 193 197 210 197 210 210 198 212 206 125 1. 222 231 235 251 235 248 251 236 248 244 - 2 254 263 267 286 267 283 289 267 276 276 - 2. 276 288 292 311 289 308 314 292 303 302 - 3 298 313 317 337 311 333 340 317 326 327 - Table 13 External dimensions (Unit: mm) Actuator model no. H φB B E Plain bonnet Extension bonnet Type 1 Extension bonnet Type 2 Integral cast type Welded type PSA1D, R 416 566 726 941 218 230 40 HA2D, R 450 600 760 975 267 281 40 a. For PSA actuator b. For HA actuator B H E A B H E A