Please, read ‘Terms and Conditions’ from following URL before the order and use. http://www.azbil.com/products/bi/order.html (11) 1-12-2 Kawana, Fujisawa Kanagawa 251-8522 Japan http://www.azbil.com/ Specifications are subject to change without notice. No part of this publication may be reproduced or duplicated without the prior written permission of Azbil Corporation. 1st edition: Apr. 2001 7th edition: Aug. 2015 Figure 5 Actuator orientation Note)Indicate by position number when installation other than the standard type is required. No. 1 (Standard type) No. 2 No. 3 No. 4 Ordering information When ordering, please specify; 1) 2) 3) 4) 5) 6) 7) 8) Model Number: HLC Nominal size × Cv required Type and rating of end connections Body and trim material Type of bonnet Valve and plug characteristics Type of actuator, necessity of manual hand wheel, air pressure to diaphragm Valve action (direct or reverse) 9) 10) 11) 12) 13) 14) 15) Accessories (pressure regulator with filter and etc.) Special requirement of oil/water free treatment, copper free treatment, etc. Name of flow medium Normal flow and maximum required flow Pressure of flow medium, upstream and downstream pressure at maximum and minimum, required flow Temperature and specific gravity of flow medium Viscosity of flow medium, inclusive or exclusive of slurry Side-mounted hand wheel Side-mounted hand wheel Flow direction Flow direction Positioner Side-mounted hand wheel Flow direction Flow direction Positioner Positioner Side-mounted hand wheel Flow direction Flow direction Positioner Side-mounted hand wheel Flow direction Flow direction Positioner Positioner