No. SS2-8113-0300 Azbil Corporation - 22 - Figure 8 Actuator orientation Note) Indicate by position number when installation other than the standard type is required. Ordering information When ordering, please specify; 1) 2) 3) 4) 5) 6) 7) 8) 9) Model number: HTS Nominal size × Port size Type and rating of end connections Body and trim material, necessity of hardening Type of bonnet Valve and plug characteristics Type of actuator, air pressure to diaphragm Valve action (direct or reverse) Accessories (positioner, hand wheel, pressure regulator with filter and etc.) 10) 11) 12) 13) 14) 15) Special requirement of degreasing, copper free treatment, and etc. Name of flow medium Normal flow and maximum required flow Pressure of flow medium, upstream and downstream pressure at maximum and minimum, required flow Temperature and specific gravity of flow medium Viscosity of flow medium, inclusive or exclusive of slurry Side-mounted hand wheel (PSA1, HA and VA5 Actuator) (PSA6 Actuator) (PSA7 and DAP Actuator) Side-mounted hand wheel Flow direction Flow direction Positioner Side-mounted hand wheel Flow direction Flow direction Positioner Positioner Side-mounted hand wheel Flow direction Flow direction Positioner Side-mounted hand wheel Flow direction Flow direction Positioner Side handle Flow direction Flow direction Positioner Side handle Flow direction Flow direction Positioner Side handle Positioner Side handle Flow direction Flow direction Positioner Side handle Flow direction Flow direction Positioner Positioner Side handle Flow direction Flow direction Positioner Side handle Flow direction Flow direction Positioner Positioner Flow direction Flow direction Side handle Positioner Side Positioner handle Side handle Flow direction Flow direction Positioner No. 1 (Standard type) No. 2 No. 3 No. 4 No. 1 (Standard type) No. 2 No. 3 No. 4 No. 1 (Standard type) No. 2 No. 3 No. 4