No. SS2-8113-2610 Azbil Corporation - 6 - Note) “H” dimensions are applicable when a hand wheel is not provided. When a hand wheel is used, add the dimensions of hand wheel specified on specification sheets (No.SS2-8213-0500 for Type HA). Figure 3 Actuator orientation Note) Indicate position number when installation other than the standard type is required. Table 6 External dimensions [Unit: mm] Nominal size (inches) Actuator model No. H B .. B Plain bonnet Extension bonnet 1 PSA1D, R 431 586 230 218 HA2D, R 465 620 281 267 1. PSA1D, R 441 591 230 218 HA2D, R 475 625 281 267 HA3D, R 580 730 363 350 2 HA1D, R 400 550 230 218 HA2D, R 475 625 281 267 HA3D, R 580 730 363 350 2. HA2D, R 545 695 281 267 HA3D, R 600 750 363 350 HA4D, R 840 990 520 470 3 HA2D, R 555 705 281 267 HA3D, R 610 760 363 350 HA4D, R 840 990 520 470 4 HA2D, R 555 710 281 267 HA3D, R 610 765 363 350 HA4D, R 845 995 520 470 Ordering information When ordering, please specify; 1) 2) 3) 4) 5) 6) 7) 8) 9) Model number: HAF Nominal size × Port size Type and rating of end connections Body and trim material, necessity of hardening Type of bonnet Valve and plug characteristics Type of actuator, air pressure to diaphragm Valve action (direct or reverse) Accessories (positioner, hand wheel, pressure regulator with filter and etc.) 10) 11) 12) 13) 14) 15) Special requirement of degreasing, copper free treatment, and etc. Name of flow medium Normal flow and maximum required flow Pressure of flow medium, upstream and downstream pressure at maximum and minimum, required flow Temperature and specific gravity of flow medium Viscosity of flow medium, inclusive or exclusive of slurry Side-mounted hand wheel Side-mounted hand wheel Flow direction Flow direction Positioner No.1 (Standard type) Side-mounted hand wheel Flow direction Flow direction Positioner Positioner No.2 Side-mounted hand wheel Flow direction Flow direction Positioner No.3 Side-mounted hand wheel Flow direction Flow direction Positioner No.4 Positioner