Azbil Corporation No. SS2-8114-0200 - 3 - Permissible vibration 2 G / 100 Hz Output Analog feedback 4 to 20 mA (For proportional control) Contact feedback: Open/Close 2 points, contact capacity 5A, 125V AC or more. Resistance feedback: With 135 Ω potentiometer (accuracy 135 Ω 10%, linearity 1%) Manual operation With multi-turn lever Additional specifications (by special order) . Special inspection Flow characteristics inspection, material inspection (Material certificate), non-destructive inspection, steam inspection, low-temperature inspection . With drain plug . Double gland . Steam jacket . Oil/water free treatment . Stainless steel (SUS304) nuts and bolts for atmospheric exposure . Yoke material (SCPH2) . Sand-/dust preventive measure . Vacuum service Performance Rated Cv value Refer to Table 3. Flow characteristics Refer to Figure 1. Inherent rangeability Refer to Table 3. (Rangeability 75:1 is available as option for Rated Cv larger than 1.0) Allowable differential pressure Refer to Table 9 and Table 10. Leakage specification . Contoured type plug IEC 60534-4:2006 or JIS B 2005-4:2008 Standard..... Class IV: Leakage less than 0.01% of maximum valve capacity. Option........ Leakage less than 0.001% of maximum valve capacity. Class IV: Leakage less than 0.00001% of maximum valve capacity Accuracy Within ± 2% F.S. Dead band Within 1% F.S. Hysteresis error Within 2% F.S. Linearity Within ± 2% F.S. Operating time Rated travel 14.3 mm; 12 sec. (no-load, reference value) Dimensions Refer to Figure 6 and Table 13 and Table 14. Weight Refer to Table, 15 and 16. Block diagram Refer to Figure 7. Terminal connection Refer to Figure 8. Finish Valve body and bonnet; Blue (Munsell 10B5/10) or silver. Actuator; Silver 6 2