No. SS2-8114-0200 Azbil Corporation - 8 - Allowable differential pressure Note) Take care not to cause the maximum allowable differential pressure to exceed the maximum operating pressure designated by ANSI B16. 34-1981 or JIS B2201-1984. Note) Take care not to cause the maximum allowable differential pressure to exceed the maximum operating pressure designated by ANSI B16. 34-1981 or JIS B2201-1984. Note) Take care not to cause the maximum allowable differential pressure to exceed the maximum operating pressure designated by ANSI B16. 34-1981 or JIS B2201-1984. Note) Take care not to cause the maximum allowable differential pressure to exceed the maximum operating pressure designated by ANSI B16. 34-1981 or JIS B2201-1984. Table 9 Contoured type metal seat (%CF, LCF, %C, LC) : PTFE packing Actuator model No. Differential pressure (by Cv value) kPa {kgf/cm2} Below 0.25 0.4 0.63 1.0 1.6 2.5 4.0 6.3 10.0 14.0 EA2 9810 {100} 9810 {100} 9810 {100} 9810 {100} 9810 {100} 9810 {100} 9810 {100} 5830 {59.5} 4350 {44.4} 2690 {27.4} Table 10 Contoured type soft seat (%TF, LTF, %T, LT) : PTFE packing Actuator model No. Differential pressure (by Cv value) kPa {kgf/cm2} Below 0.25 0.4 0.63 1.0 1.6 2.5 4.0 6.3 10.0 14.0 EA2 2940 {30.0} 2940 {30.0} 2940 {30.0} 2940 {30.0} 2940 {30.0} 2940 {30.0} 2940 {30.0} 2940 {30.0} 2940 {30.0} 1870 {19.1} Table 11 Contoured type metal seat (%CF, LCF, %C, LC) : Graphite packing “P6610CH+P6528” (+230 to +500 °C) Actuator model No. Differential pressure (by Cv value) kPa {kgf/cm2} Below 0.25 0.4 0.63 1.0 1.6 2.5 4.0 6.3 10.0 14.0 EA2 9810 {100} 9810 {100} 9810 {100} 9810 {100} 9810 {100} 7540 {76.8} 7540 {76.8} 4090 {41.7} 3050 {31.1} 1880 {19.1} Table 12 Metal seat (%VF, LTF, %V, LV) : Graphite packing “P6610CH+P8590” (+500 to +566 °C) Actuator model No. Differential pressure (by Cv value) kPa {kgf/cm2} Below 0.25 0.4 0.63 1.0 1.6 2.5 4.0 6.3 10.0 14.0 EA2 9810 {100} 9810 {100} 9810 {100} 9610 {97.9} 9610 {97.9} 5930 {60.4} 5930 {60.4} 3220 {32.8} 2400 {24.4} 1480 {15.0}