No. SS2-PTG300-0100 Azbil Corporation - 4 - Oil and water free finish Oil and water are removed from the wetted parts before shipment. Electrolytic grinding (For ferrule type only) The surface of the wetted parts is smoothed by electrolytic grinding. Passive state finish (For ferrule type only) The surface of the wetted parts is treated with a passive state finish to form a protective film to increase resistance to corrosion. Test report The test report indicates the results of appearance, I/O characteristics, insulation resistance, and breakdown voltage tests. Material certificate The material certificate shows the chemical composition, heat-treatment conditions, and mechanical properties of the materials used for the wetted parts. The transmitter can be easily zeroadjusted in the field with a flat-blade screwdriver. Withstand pressure test The withstand pressure test result sheet shows the results of a pressure resistance test (under water pressure for 10 minutes) performed on the wetted parts. Strength calculation sheet The strength calculation sheet indicates the strength of the meter body cover, flanges, bolts, etc. Traceability certificate This certificate consists of three parts: the transmitter's measurement control system configuration diagram, a calibration certificate, and a test report. Mounting bracket Bracket for 2-inch pipe or wall mounting (For thread connection type and ferrule remote sealed type) Withstand pressure and air tight test (for general purposes) The withstand pressure and air tight test result sheet shows the results of a pressure resistance test (under water pressure for 10 minutes) and a gas-tightness test (using N2 gas for 10 minutes) performed on the wetted parts.