Azbil Corporation No. SS2-MCB100-0100 - 5 - Notice for installation To fully enjoy the performance of the device, please choose an appropriate location according to the following. Notice after installation  WARNING When removing the device from the piping, make sure that there is no line pressure or process fluid inside of the device. Removing the device before depressurizing may result in serious injury.  CAUTION Do not use the device as a foothold. It may cause injury or damage of the device. Notice for environment . Install the flowmeter in a location with an ambient temperature of -25°C to 60°C (-13°F to 140°F) and an ambient humidity of 5 to 100%RH to prevent equipment malfunction or output errors. . Do not install the flowmeter near high-current power lines, motors or transformers to prevent damage from electromagnetic induction, which can cause equipment malfunction or output errors. . Do not install the flowmeter in a location subject to severe vibration or in a highly corrosive atmosphere. The converter and detector can be damaged. . When install some electromagnetic flowmeters in closer location, keep minimum 500mm (20 inch) space from each flowmeter. Closer electromagnetic flowmeter installation may cause magnetic interference each other and results in output errors. Notice for application . Electrochemically homogeneous fluid . Install the device where the process fluid is electrochemically homogeneous. If two kind of process fluids are mixed at the upstream side, the process fluid must be uniformly mixed. . The application which the electric conductivity changes or non-homogeneous fluid . Do not use the device for the following fluid conditions even if the electric conductivity, temperature, and pressure are within the device specifications. Those fluid may cause of inaccurate flow measurement. . Fluids that have sufficient conductivity at high temperature but do not meet the conductivity requirement at room temperature (about 20°C (68°F)). (e.g. fatty acids and soap) . Some fluids contain surfactant (e.g. rinse, shampoo and CWM (coal water mixture)) . Insulating adhesive materials (eg. kaolinite, kaolin, calcium stearate) 4 13