No. SS2-MGG410-0100 Azbil Corporation - 2 - COMMUNICATION (SELECTABLE) . DE protocol . HART protocol (HART Rev. 5) APPLICATIONS Available for various applications such as: Pulp and Paper Pulp slurries, chemicals, green liquor, white water, white liquor, black liquor, corrosive fluid, industrial water, waste water Petroleum/Petrochemical/Chemicals Corrosive fluid, electrolyte, dyestuffs, chemicals, industrial water, waste water Water/Waste water Tap water, sewage water, sludge, sediment slurries, effluent Food and Beverage Beer, milk, juice, wine, liquor, soy sauce, potable water, industrial water, waste water Steel/Metal and Mining Alumina slurry, cooling water, sea water, corrosive fluid, industrial water, waste water Machinery Corrosive fluid, cooling water, circulating water, waste water Building/Construction Building material slurry, sediment slurry, cement, industrial water Electric Power/Gas Corrosive fluid, cooling water, industrial water, waste water FUNCTIONAL SPECIFICATIONS Type of protection Enclosure rating JIS C 0920 Waterproof NEMA TYPE4X IEC IP66 Hazardous area certification: FM approval Nonincendive for Class I, Division 2, Groups A, B, C & D, T5; Class II, Division 2, Groups F & G, T5; Class III, Division 2, T5; -25 °C < Tamb < +60 °C CSA certification Class I, Division 2, Groups A, B, C, & D, T4; Class II, Division 2, Groups E, F & G, T4; Class III, T4; -25 °C < Tamb < +60 °C Power supply Normal operating voltage: AC 100 to 120 V, AC 200 to 240 V, 47 to 63 Hz Operational voltage limit: AC 90 to 130 V, AC 180 to 250 V, 47 to 63 Hz Power consumption 10 W max. (AC 90 to 130 V) 11 W max. (AC 180 to 250 V) Lightning protection 12 kV, 1000 A Equipped with the lightning arrester in the power source and external input and output terminals. Power failure An EEPROM retains data record of the totalized value when pulse output is used (retention period approximately 10 years). EMC conformity standards EN61326 Ship classification Approved by NK (Nippon Kaiji Kyokai) Approval No.: 11A008 Some model numbers selectable by the model selection table do not meet the requirements for NK approval. Check sections I (power supply) and II (output signal/communication) in the model selection table. Note: The MGG14C cannot be installed on the bridge or deck of the ship. In the case of a remote model, the cables between the converter and detector must be covered with a flexible metal conduit. Input signal Flow rate signal Electromotive force which is proportional to the average flow velocity. Contact input Solid-state contact or no-voltage contact (2 max.) Output signal Analog output 4 to 20 mA DC Digital output DE Analog or digital output is selectable.