No. SS2-MGG410-0100 Azbil Corporation - 4 - Compensation coefficient (in the ADVANCED MODE) Compensation coefficient used to multiply the output flow rate as required. Built-in counter function Totalizer According to the pulse scale setting, it totals one count at a time. If double range of normal/reverse flow measurement function is set, it totals one count at a time for normal and reverse flows. If single range of flow measurement is set, it totals one count at a time only for normal flow direction. Totalizer with presetting function A preset value (target totalized value) can be set between 0000000000 and 9999999999. The counting method is same as that of the standard totalizer. Normal/reverse flow difference totalizer The difference in flow volumes in the normal or reverse flow directions is calculated and counted. Contact input function External 0 % lock input Forces outputs (analog, digital, pulse) to the zero flow rate signal level. External automatic zero adjustment input Adjust zero. External range switching input Switches two flow measurement ranges. Two flow measurement ranges: Dual range for nominal direction. Normal/reverse range Built-in counter reset input Resets the totalized value in the built-in counter. Contact output function Alarm output Outputs an alarm under the following conditions. . Self-diagnostic result . Empty pipe detection . High/low limit alarm Range switching output Outputs the status of flow range. . Large/small in the dual range . Normal/reverse Counter preset status output Activates when the counter reaches the preset value. Self-diagnostic result output Activates only when a critical failure appears by the self-diagnostic. Empty detection output Activates only when empty status (when electrodes are in contact with air) is detected. Please make sure that there is no air trap inside of the detector and process fluid conductivity should be 30 mS/cm or greater for functioning properly. High/low limit alarm output Activates when a high/low limit occurs. Two-stage flow rate alarm output (with two contact outputs) Activates when the first high/low limit alarm (H/L) occurs and the second high/low limit alarm (HH/ LL) occurs.