- 1 - 5th Edition No. SS2-8213-0510 OVERVIEW The Multismotor Model HL is a multi-spring type, lever-actuated diaphragm motor featuring small size and lightweight. This motor, employing a lever to extend motion of the actuator stem, is used to operate control rods of dampers, cock valves, or other items. SPECIFICATIONS Types 1) Direct action As the air pressure fed to the top chamber of the diaphragm case increases, the actuator stem moves downward. 2) Reverse action As the air pressure fed to the bottom chamber of the diaphragm case increases, the actuator stem moves upward. Material . Diaphragm case SS400 . Diaphragm Cloth embedded ethylene propylene rubber . Actuator stem SUS403 stainless steel . Yoke FC200 . Lever S45C . Fork S20C . Pin SUS304 . Base SS400 Spring range 20 to 98 kPa {0.2 to 1.0 kgf/cm2} 80 to 240 kPa {0.8 to 2.4 kgf/cm2} Supply pressure 140 to 390 kPa {1.4 to 4.0 kgf/cm2} Air connection Rc 1/4 or 1/4NPT internal thread Action Model Direct HL2D HL3D HL4D Reverse HL2R HL3R HL4R Ambient temperature -30°C to +70°C Optional accessories Positioner*, pressure regulator with filter, hand wheel*, limit switch, solenoid valve, motion transmitter, booster relay, lock-up valve, and others. Note) 1) For the optional items, refer to the specification sheets and installation drawing of respective accessories. 2) Accessories with the asterisk mark (*) are selected from the following types depending on the actuators to be combined. Performance Output Refer to Table 2. Accuracy Refer to Table 1. Dimensions and weight Refer to Figure 1, 2 and 3 and Table 6. Finish Blue (Munsell 10B5/10), silver or other specified colors. Actuator Positioner Hand wheel P/P I/P Top Side HL2 to 4 HTP AVP/HEP THM - CV3000 Series Multismotor Multi-Spring Type, Lever-Actuated Diaphragm Motors Model HL 7 14 Specifications are subject to change without notice. “This product is designed for general industrial use.”