Azbil Corporation No. SS2-AVP200-0100 - 5 - MODEL SELECTION Analog signal (4 to 20 mA DC) without travel transmission. Analog signal (4 to 20 mA DC) with travel transmission. Analog signal (4 to 20 mA DC) with HART Communication protocol Note) *1 One set of TIIS Flameproof cable gland shall be attached for model AVP200. Two sets are for model AVP201. *2 Standard finish is equal to previous Y138A. Corrosion proof is equal to previous Y138B. *3 No domestic sales in Japan due to Non-SI unit. *4 For TIIS Flameproof model, these elbows should be put on the supplied cable gland. Code “A” and “C” can not be selected simultaneously. *5 Select “YW” or “YJ” for old-type motion connectors. *6 Code “W” of option (10) must be selected. *7 Select model AVP200/AVP201 only when the direction of drain of the pressure regulator with filter on the control valve is downward (ground). *15 Select the option with the restoration feedback lever, if GOM manufactured before April, 1988. Select the option ‘8’ (Accessory bracket for GOM actuator - Use the case of existing GOP) if the existing control valve assembled with GOP and the accessories such as the Lock-up valves and solenoid valves. Configuration Following shows default and optional settings of each configurable parameter of SVP. Unless otherwise specified, the Smart Valve Positioner will be shipped in the following configuration. 1. Input control signal 4 to 20 mAThe minimal span for custom range = 4mA 2. Output characteristic LinerEQ or QO can be ordered or set by user. 3. Valve action Direct (Plug above seat)Reverse (Plug below seat) can be ordered or set by 4. Output signal for position transmission 4 to 20 mADE also selectable AVP200 (1) (2) (3) (4) (5) - (6) (7) (8) (9) - (10) AVP201 (1) (2) (3) (4) (5) - (6) (7) (8) (9) - (10) AVP202 (1) (2) (3) (4) (5) - (6) (7) (8) (9) - (10) Connection Air piping Electrical connection Mounting thread Code (1) Structure Water-proof Rc1/4 G1/2 M8 X Water-proof 1/4NPT internal 1/2NPT internal 5/16-18 P TIIS Flameproof with cable gland *1 Rc1/4 G1/2 M8 E (2) Finish Standard (Baked acrylic) *2 S Corrosion proof (Baked epoxy) *2 B Silver finish (Baked acrylic) D (3) Positioner action Direct action - Air pressure increases with control signal increase D Reverse action - Air pressure decreases with control signal increase R Air supply range Pressure gauge scale Max. regulator setting (4) Supply air pressure classification 130