Azbil Corporation No. SS2-KFL100-0100 - 5 - ATTENTION Attention in usage . In the following cases, our standard displacement type level instrument might be unsuitable to the usage because it produces i t with measuring range = float length H. 0% or around 100% levels are detected in the normal operation. When output signals are the continuous output signals of 4mA or less or 20mA or more. . Set the float bottom to the zero point when you execute the actual liquid adjustment after the displacement type level instrument is installed at the job site. The output change doesn’t generate if the measurement fluid does not contact with the float on the structure of the instrument. Might it cause in the lower limit or the upper limit of the measuring range when setting it to the zero point excluding the float bottom and trouble be caused in the measurement dead-band or characteristic of the linearity. An appropriate adjusting method: Set the float bottom to the zero point. An improper adjusting method: Set it to the zero point excluding the float bottm. Attention in installation Zero point Measuring range Float full length H Zero point Measuring range Measurement dead-band Zero point Measuring range Measurement dead-band  WARNING . When install it, the gasket of process connection is required to set without rum off the edge. . It causes a liquid leakage and the output error. Please do not use it excluding pressure, the temperature, and connected standard for which this specification sheet specified. It might cause a big accident because of damage and a liquid leakage.  CAUTION . Please do not use this instrument for the work stand etc. after install it. The equipment might be damaged and it causes the injury. . Please do not appropriate the tool etc. to the glass part of the display. It is likely to injure damaging the glass. . Please set it up correctly. When the installation is insufficient, it might violate the output error and the corresponding rule. . Because this instrument is a heavy lift, the work stand is noted, and the safety shoe is worn. Please do and do the installation operation. Ordering information 1) Model number (At the specific gravity measurement... 'Z' is filled in on a basic model number end.) 2) Name of gas, liquid name, and type of gas, design temperatures, and pressures (Especially, for the High pressure gas recognition equipment.) 3) Specific gravity, pressure, and temperature of liquid 4) Dimension to the upper part of float lower side of the flange (L1) mm 5) The specific gravity measurement (range of specific gravity) 6) For the boundary surface measurement (specific gravity of upper layer liquid and lower liquid) 7) Optional specification 6 5