No. SS2-PCA100-0100 - 2 - SPECIFICATIONS Input (1) 1 to 5 V DC or 4 to 20 mA DC input Input resistance 1 M.. (1 to 5 V DC) 10 .. (4 to 20 mA DC) Scaling -9999 to 9999 Measurement error ± (0.1% indicated value + 5 digits) (2) Thermocouple input R sensor: 0 to 1749 °C (32 to 3180 °F) K sensor: -199 to 1349 °C (-326 to 2460 °F) J sensor: -199 to 899 °C (-326 to 1650 °F) T sensor: -199 to 399 °C (-326 to 750 °F) B sensor: 600 to 1799 °C (1112 to 3270 °F) Measurement error:± (0.3% indicated value + 1 °C) (3) Resistance temperature element Pt100. -199.9 to 649.9 °C (-327.8 to 999.9 °F) Measurement error ± (0.2% indicated value + 0.3 °C) Output (1) 4 to 0 mA DC (isolation output) Load resistance : 0 to 600. Linear accuracy : ± 0.1% of scale value Scaling :-9999 to +9999 (2) Alarm output (relay contact, common) Output contacts 2 contacts Comparison methods 2 point independent setting (H/L, H/HH, or L/LL) Contact capacity 125 V AC / 0.5A or 250 V AC / 0.1 A Output delay 0 - 100s, divisible by 1s Power Source 90 - 132 V AC or 180 - 264 V AC, 50 / 60 Hz Switchable inside unit Loop Check Function Output 4 to 20 mA DC Output settings Division possible up to 0.1% from 0 to 100% Outputs 4 to 20 mA DC corresponding to set % Linear accuracy ± 0.1% of scale value Load resistance 0 to 600 .. Indication E is displayed in the most significant digit position of the LED display when this function is chosen. Reset Function Returns to alarm comparison output Hold Function Saves alarm comparison output, measured data Display Main display 7-segment red or green LEDs 4-character display, LED/character height 15 mm With open input 0000 (blinking) Alarm display two-point AL1 / AL2, red LEDs Input / Function Switching Switched using dip-switches SW1: Pt100. / °C SW2: R sensor / °C SW3: K sensor / °C SW4: J sensor / °C SW5: T sensor / °C SW6: B sensor / °C SW7: Pt100. / °F SW8: R sensor / °F SW9: K sensor / °F SWA: J sensor / °F SWB: T sensor / °F SWC: B sensor / °F SWD: 1-5 V DC or 4-20 mA DC SWE: loop check function Sampling Frequency 2.5 times / sec Indication Frequency F 400 ms M 800 ms (average of 2 sampled values) S 2 s (average of 5 sampled values) Ambient Temperature Range 0 to 50 °C Storage Temperature Range -20 to 70 °C Case Material ABS Resin Data Setting set using dip-switches inside front panel Installation Panel installation using special fasteners Weight approx. 500 g